- 您現在的位置：買賣IC網 > PDF目錄371030 > MC33025 (Motorola, Inc.) High Speed Double-Ended PWM Controller PDF資料下載
參數資料
| 型號： | MC33025 |
| 廠商： | Motorola, Inc. |
| 英文描述： | High Speed Double-Ended PWM Controller |
| 中文描述： | 高速雙端PWM控制器 |
| 文件頁數： | 11/20頁 |
| 文件大小： | 516K |
| 代理商： | MC33025 |
MC34025 MC33025
11
MOTOROLA ANALOG IC DEVICE DATA
CT
Vref
RDT
RT
4
Oscillator
Figure 23. Dead Time Addition
5
6
Additional dead time can be added by the addition of a dead time resistor from
Vref to CT. See text on oscillator section for more information.
5.0 V
0 V
CT
RT
Oscillator
Figure 24. External Clock Synchronization
4
5
6
The sync pulse fed into the clock pin must be at least 3.9 V. RT and CT need
to be set 10% slower than the sync frequency. This circuit is also used in voltage
mode operation for master/slave operation. The clock signal would be coming
from the master which is set at the desired operating frequency, while the slave
is set 10% slower.
Figure 25. Resistive Current Sensing
ISense
9
The addition of an RC filter will eliminate instability caused by the leading edge spike
on the current waveform. This sense signal can also be used at the ramp input pin for
current mode control. For ramp compensation it is necessary to know the gain of the
current feedback loop. If a transformer is used, the gain can be calculated by:
Ai
RSense
turns ratio
Figure 26. Primary Side Current Sensing
Rw
ISense
9
Figure 27. Primary or Secondary Side
Current Sensing
0
ISense
Rw
9
Ai
R
w
turns ratio
The addition of an RC filter will eliminate instability caused by the leading edge spike on the current waveform. This sense signal can also be used at the ramp input
pin for current mode control. For ramp compensation it is necessary to know the gain of the current feedback loop. The gain can be calculated by:
相關PDF資料 |
PDF描述 |
|---|---|
| MC33025DW | High Speed Double-Ended PWM Controller |
| MC33025P | High Speed Double-Ended PWM Controller |
| MC34025P | Battery-Backup Supervisors for RAM Retention 8-MSOP -40 to 85 |
| MC3403 | Amplifiers and Comparators |
| MC34050P | Dual EIA-422/423 Transceivers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC33025DW | 功能描述:電流型 PWM 控制器 Dual Output Voltage RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| MC33025DWG | 功能描述:電流型 PWM 控制器 Dual Output Voltage or Current Mode PWM RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| MC33025DWR2 | 功能描述:電流型 PWM 控制器 Dual Output Voltage RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| MC33025DWR2G | 功能描述:電流型 PWM 控制器 Dual Output Voltage or Current Mode PWM RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| MC33025P | 功能描述:電流型 PWM 控制器 Dual Output Voltage RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
發布緊急采購，3分鐘左右您將得到回復。