- 您現在的位置：買賣IC網 > PDF目錄375837 > FM1808 (Electronic Theatre Controls, Inc.) 4Kb FRAM Serial 3V Memory PDF資料下載
參數資料
| 型號： | FM1808 |
| 廠商： | Electronic Theatre Controls, Inc. |
| 元件分類： | DRAM |
| 英文描述： | 4Kb FRAM Serial 3V Memory |
| 中文描述： | 4Kb的鐵電串行3V的記憶 |
| 文件頁數： | 4/12頁 |
| 文件大小： | 89K |
| 代理商： | FM1808 |
Ramtron
FM1808-70
27 July 2000
4/12
The entire memory operation occurs in a single bus
cycle. Therefore, any operation including read or write
can occur immediately following a write. Data polling,
a technique used with EEPROMs to determine if a
write is complete, is unnecessary.
Pre-charge Operation
The pre-charge operation is an internal condition
where the state of the memory is prepared for a new
access. All memory cycles consist of a memory
access and a pre-charge. The pre-charge is user
initiated by taking the /CE signal high or inactive. It
must remain high for at least the minimum pre-charge
timing specification.
The user dictates the beginning of this operation
since a pre-charge will not begin until /CE rises.
However, the device has a maximum /CE low time
specification that must be satisfied.
Endurance and Memory Architecture
Data retention is specified in the electrical
specifications below. This section elaborates on the
relationship between data retention and endurance.
FRAM offers substantially higher write endurance
than other nonvolatile memories. Above a certain
level, however, the effect of increasing memory
accesses on FRAM produces an increase in the soft
error rate. There is a higher likelihood of data loss but
the memory continues to function properly. This
effect becomes significant only after 100 million (1E8)
read/write cycles, far more than allowed by other
nonvolatile memory technologies.
Endurance is a soft specification. Therefore, the user
may operate the device with different levels of cycling
for different portions of the memory. For example,
critical data needing the highest reliability level could
be stored in memory locations that receive
comparatively few cycles. Data with frequent changes
or shorter-term use could be located in an area
receiving many more cycles. A scratchpad area,
needing little if any retention can be cycled virtually
without limit.
Internally, a FRAM operates with a read and restore
mechanism similar to a DRAM. Therefore, each cycle
be it read or write, involves a change of state. The
memory architecture is based on an array of rows and
columns. Each access causes an endurance cycle for
an entire row. Therefore, data locations targeted for
substantially differing numbers of cycles should not
be located within the same row. To balance the
endurance cycles and allow the user the maximum
flexibility, the FM1808 employs a unique memory
organization as described below.
The memory array is divided into 32 blocks, each
1Kx8. The 5upper address lines decode the block
selection as shown in Figure 2. Data targeted for
significantly different numbers of cycles should be
located in separate blocks since memory rows do not
extend across block boundaries.
Figure 2. Address Blocks
0000h
0400h
03FFh
0800h
07FFh
0C00h
0BFFh
F000h
EFFFh
F400h
F3FFh
F800h
F7FFh
FC00h
FBFFh
FFFFh
Block 0
Block 1
Block 2
Block 27
Block 28
Block 29
Block 30
Block 31
Block 3
Block 4
1000h
0FFFh
Each block of 1Kx8 consists of 256 rows and 4
columns. The address lines A0-A7 decode row
selection and A8-A9 lines decode column selection.
This
scheme
facilitates
distribution of cycles across the rows of a block. By
allowing the address LSBs to decode row selection,
the user avoids applying multiple cycles to the same
row when accessing sequential data. For example, 256
bytes can be accessed sequentially without accessing
the same row twice. In this example, one cycle would
be applied to each row. An entire block of 1Kx8 can
be read or written with only four cycles applied to
each row. Figure 3 illustrates the organization within a
memory block.
a
relatively
uniform
相關PDF資料 |
PDF描述 |
|---|---|
| FM1808-120-P | 4Kb FRAM Serial 3V Memory |
| FM1808-70-P | 4Kb FRAM Serial 3V Memory |
| FM1808-70-S | 4Kb FRAM Serial 3V Memory |
| FM200TU-07A | HIGH POWER SWITCHING USE INSULATED PACKAGE |
| FM200TU-2A | HIGH POWER SWITCHING USE INSULATED PACKAGE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| FM1808-120-P | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:256Kb Bytewide FRAM Memory |
| FM1808-120-S | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:256Kb Bytewide FRAM Memory |
| FM1808-70-P | 功能描述:F-RAM 256K (32Kx8) 70ns 5V RoHS:否 存儲容量:512 Kbit 組織:64 K x 8 接口:SPI 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube 制造商:Cypress Semiconductor |
| FM1808-70-PG | 功能描述:F-RAM 256K (32Kx8) 70ns 5V RoHS:否 存儲容量:512 Kbit 組織:64 K x 8 接口:SPI 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube 制造商:Cypress Semiconductor |
| FM1808-70-PG | 制造商:Ramtron International Corporation 功能描述:Nonvolatile SRAM Memory IC Memory Type:F |
發布緊急采購，3分鐘左右您將得到回復。